• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE WIRING HARNESS AND INTERCONNECT HARNESS REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_139
ENGINE WIRING HARNESS AND INTERCONNECT HARNESS REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_141

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  118    119    120    121    122  123  124    125    126    127    128  
TM 5-1940-277-34 ENGINE WIRING HARNESS AND INTERCONNECT HARNESS REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS INSPECTION 1. Engine wiring Visually inspect Use wiring harness (1) wiring harness diagram.  Repair and interconnect for broken or broken connec- harness (5) damaged connec- tions and wire. tions, broken If insulation wires or frayed is damaged or cracked replace cable. insulation. REPAIR 2. Engine wiring a. Broken Remove old con- Use pliers, wire harness (1) and connection nector (2) by stripper and interconnect pulling off or crimper.  Cut harness (5) removing nut only enough wire and washer as to square up end. required.  If wire end frayed cut square.  Strip about 1/4 in of insulation from wire.  Select correct replace- ment connector (same as one removed) and fit to wire.  Crimp connector to wire.  Connect wire to terminal. 2-111







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.