• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
MAST WIRING HARNESS REPLACEMENT INSTRUCTIONS - UPPER (Continued) - TM-5-1940-277-34_162
MAST WIRING HARNESS REPLACEMENT INSTRUCTIONS - UPPER (Continued) - TM-5-1940-277-34_164

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  141    142    143    144    145  146  147    148    149    150    151  
TM 5-1940-277-34 MAST WIRING HARNESS REPLACEMENT INSTRUCTIONS - UPPER (Continued) LOCATION ITEM ACTION REMARKS f. Wiring Remove spiral Unwind from wire. harness (10) wrap (16) from Retain for reuse. all exposed sec- tions of harness. NOTE Next step involves items located at points wires enter and exit mast section. g. 5 grommets a. Pry out of Use screwdriver. (17) mast. b. Cut off wires. Use knife. c. Discard. h. Wiring har- a. Tie a cord to ness (10) each wire indicated in figure with b. Start with Stop pulling when upper naviga- each cord has tion light been pulled wires and through mast. working way down mast to lower light positions, pull each wire without an attached cord out of mast frame with attached cord. Carefully feeding other end of wire being pulled into mast frame. 2-137







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.