• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
STARTER MOTOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_241
STARTER MOTOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_243

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  220    221    222    223    224  225  226    227    228    229    230  
TM 5-1940-277-34 STARTER MOTOR REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS b. Screw (49) Install and Use flat tip and lock- tighten. screwdriver. washer (50) c. Nut (43) Tighten. Use 1/2 in open end wrench. 24. Pinion (28) a. Lock Fit to pinion Make sure 45° collar (29) sleeve. chamfer, inside collar, faces solenoid. b. Spring (34), Fit to sleeve. Make sure snap trip collar ring seats (33), new squarely in snap ring (32) locking groove. 25. Drive end shield a. Resistor (41), Insert in recess Use blind (1) bushing in shield. riveter. spacers (42), Secure resistor rivet (38) and bushing spacers with rivet. b. Resistor lead Secure lead to Use flat tip (37), washer lug on solenoid screwdriver. (40) and moving contact screw (36) using washer and screw. 26. Pinion sleeve 6 lock balls Insert balls Use small screw- (76) (30) and 4 over- into pinion driver with spot speed balls (31) sleeve holes. of grease to feed in balls.  Hold in place with smear grease. 2-219







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.