• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_275
INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_277

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  254    255    256    257    258  259  260    261    262    263    264  
TM 5-1940-277-34 INJECTION PUMP REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS b. Gear (16) Turn until small Use flashlight to indent mark in see indent. rear face of gear is visible through hole. c. Gear (16) Fit 1/8 in drill Use 1/8 in drill bit through timing bit. hole and seat in indent.   Move gear NOTE until drill bit is A piece of 1/8 in centered in hole. brass rod may be Remove bit when used.  Refer to centered. Appendix C, Figure C-5. d. 0-ring (11) Lightly coat with clean engine oil and position on shoulder on front face of pump mounting flange. 5. Engine e. Injection pump Fit pump to engine Pump may have to (1) keeping the stud be rotated in center of slightly to engage slotted mounting pump gear teeth to hole as much as camshaft gear possible. teeth. Change 6  2-253







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.