• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INJECTOR TEST AND REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_296
CYLINDER HEAD ASSEMBLY INSPECTION AND REPAIR INSTRUCTIONS

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  275    276    277    278    279  280  281    282    283    284    285  
TM 5-1940-277-34 INJECTOR TEST AND REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS e. Spring Screw into top of adjusting holder until pres- screw (4) sure on spring is felt. f. Copper Fit over top of washer (3) adjusting screw. g. Injector cap Screw on spring Make sure copper nut (2) adjusting screw. washer (3) re- Do not tighten. mains positioned. 13. Injector a. Nozzle Connect to Use screwdriver. tester holder (1) tester.  Pump tester pressure and rotate spring adjusting screw clockwise at same time.  Adjust until injector opens (sprays) at 2,999 psig (205 atm). b. Injector cap Torque to 37 - Use 1 in socket nut (2) 43 ft-lb. and torque wrench. 14. Injector tester Nozzle holder Retest needle Steps 1d, 1e, 1f. (1) valve back leak- If injector fails age, needle seat test replace leakage and injector. atomization. 2-275(2-276 Blank)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.