• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
OIL SUMP (PAN) INSPECTION AND REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_331
OIL SUMP (PAN) INSPECTION AND REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_333

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  310    311    312    313    314  315  316    317    318    319    320  
TM 5-1940-277-34 OIL SUMP (PAN) INSPECTION AND REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 5. Cylinder block a. Oil sump a. Apply sealant Use silicone (21) gasket (11) to both sides sealant. of gasket. b. Fit gasket to face of block using dowels for positioning. c. Apply sealant in space for gasket in front oil seal groove (23) around front main bearing cap (22). b. Front oil Fit in groove in Take care not to seal (12) front main trap timing gear bearing cap (23) housing gasket. c. Rear oil a. Make sure area seal (10) (24) under seal feet is free of sealant. b. Apply thin coat of sealant as shown. c. Fit in groove (25) in rear main bearing cap (26). d. Oil sump (6) Position on block. 2-313







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.