• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
PISTON AND CONNECTING ROD ASSEMBLY INSPECTION AND REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_459
ASSEMBLY (cont) - TM-5-1940-277-34_461

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  438    439    440    441    442  443  444    445    446    447    448  
TM 5-1940-277-34 PISTON AND CONNECTING ROD ASSEMBLY INSPECTION AND REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 9. Piston (11) a. Connecting Insert into a.  Make sure rod (4) piston. arrowhead on piston crown and FRONT mark on connecting rod are point- ing in the same direction b.  Make sure re- installed rod and piston are matched to original mate. b. Piston pin Insert. (3) c. 2 snap rings Install. Use pliers. (2) d. Rings (9) Fit to piston. Use piston ring and (10) assembly tool. Make sure inter- mediate and lower rings are fitted correct way up. (See figure.) 10. Connecting rod a. Bearing Fit bearing a.  If refitting (4) and bearing halves (8) halves, engaging original cap (8) locating tongues bearing halves in locating make sure they grooves. are mated with their original rod or cap. 3-27







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.