• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
PISTON AND CONNECTING ROD ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_467
CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  446    447    448    449    450  451  452    453    454    455    456  
TM 5-1940-277-34 PISTON AND CONNECTING ROD ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) c. Big end Lubricate with bearing clean lubrica- halves, upper ting oil. (14) and lower (7) d. Connecting Fit open end Rotate crank- rod (5) to crankshaft shaft as journal (9). necessary. e. Bearing cap a. Position on (6) and connecting bolts (4) rod (5) using dowels (15). b. Install Use 5/8 in soc- bolts, torque ket, 6 in exten- to 85 to 90 sion and torque ft-lb (11.76 wrench. to 12.45 kg f). 7. Cylinder Crankshaft (8) Check rotation Use 15/16 in block (1) after tightening socket and 1/2 each bearing in hinged cap (6) by turn- handle. ing crankshaft pulley nut (2). NOTE Repeat steps 5a - 6e for each piston. 3-35 (3-36 Blank)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.