• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CRANKSHAFT INSPECTION AND REPLACEMENT INSTRUCTIONS (cont) - TM-5-1940-277-34_503
CAMSHAFT AND CAMSHAFT BEARING INSPECTION AND REPLACEMENT INSTRUCTIONS - TM-5-1940-277-34_505

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  482    483    484    485    486  487  488    489    490    491    492  
TM 5-1940-277-34 CRANKSHAFT INSPECTION AND REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS NOTE Make   sure   to   mate   bearing   caps   to   original   connecting   arms   from   which disassembled. c. Bearing caps a. In turn, Use 5/8 in soc- (7) and position caps ket, 6 in exten- bolts (6) on connecting sion and torque rod using wrench (0 - 175 dowels. ft-lb). b. Install bolts. c. Torque bolts to 85 - 90 ft-lb (11.76 - 12.45 kg-m). 12. Cylinder block Oil pump inlet a. Insert pipe (9) pipe (10) into pump connection. b. Screw in Use 7/8 in open union (14), end wrench. bend down lock tab (13). c. Secure pipe Use 1/2 in socket bracket to and ratchet. main bearing cap (16) using cap screw (11) and washer (12). 13. Engine assembly Crankshaft Check crankshaft Use 15/16 in soc- (27) pulley nut (28) rotation after ket and 3/4 in tightening each drive handle. bearing cap. 3-73   (3-74 Blank)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.