TROUBLESHOOTING PROCEDURES (Continued)
TEST OR INSPECTION
TRANSMISSION HAS GEAR NOISE IN FORWARD OR REVERSE
Check for inadequate torque on output shaft nut.
Torque nut to 140-150 ft. lbs. If nut will not torque report to General Support.
If nut properly torqued report to General Support.
Check for loose transmission mounting bolts (refer to page 2-349).
If nut will not torque report to General Support.
If bolt properly torqued go to step 3.
Check for worn or defective flywheel damper (refer to page 2-317).
Replace defective or worn flywheel damper (refer to page 2-317).
If flywheel damper is all right report to General Support.
Change 1 2-17