• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (cont) - TM-5-1940-277-34_614
HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (cont) - TM-5-1940-277-34_616

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  593    594    595    596    597  598  599    600    601    602    603  
TM 5-1940-277-34 HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (Continued) LOCATION ITEM ACTION REMARKS c.  Drive Slide drive Lay parts in flange (7) flange out and order or tag for then remove in identification. order: main thrust washer (12), thrust bearing (13), front thrust washer (14), spacer (15), and front seal sleeve (16). 4. Bearing cap (9) a.  Seal (17) Remove. Use seal puller. Note way seal is mounted. b.  Gasket (18) Remove and discard. 5. Hydrojet a.  Key (19) Remove. Use fingers or assembly pliers if key shaft (2) sticks. b.  Reverse Remove. Slide off shaft. thrust bearing (20) c.  Reverse Remove. Slide off shaft. thrust washer (21) d.  Inner seal a.  Take two Use hand or if housing (22) bearing cap stuck too tight retaining use pliers. screws (10), screw into holes in housing. 3-187







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.