• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (cont) - TM-5-1940-277-34_616
HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (cont) - TM-5-1940-277-34_618

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  595    596    597    598    599  600  601    602    603    604    605  
TM 5-1940-277-34 HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (Continued) LOCATION ITEM ACTION REMARKS b.  Pull inner seal housing out with thrust collar (23) and needle bearing (24). c.  Separate thrust collar from housing. 6. Thrust collar (23) O-ring (25) Remove and discard. 7. Inner seal housing a.  Needle a.  Remove from Use bearing (22) bearing (24) front of puller. housing. b.  Retain all bearing parts. b.  Seal (26) Remove from rear Use seal puller. and O-Ring of housing and Note how seal is (26a) discard. positioned. 8. Hydrojet assembly Seal sleeve Slide off shaft. shaft (2) (27) 9. Intake case (1) a.  Hydrojet a.  Remove shaft Plain sleeve (28) assembly by sliding will slide out shaft (2) toward rear along with shaft. and plain of intake sleeve (28) case. b.  Slide sleeve off shaft after removal. Change 5  3-189







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.