• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ALTERNATOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_95
ALTERNATOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_97

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  74    75    76    77    78  79  80    81    82    83    84  
TM 5-1940-277-34 ALTERNATOR REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 4.    Drive end a. 3 screws Remove. Use flat tip shield (18) (29), 3 screwdriver. washers (30) Should screws be and clamping difficult to plate (31) remove, heat end shield to 212 F. b. Bearing (32) Extract. Use suitable drift if required. CLEANING, INSPECTION, TEST, AND REPAIR 5. All components a. Clean Use dry cleaning thoroughly. solvent. WARNING Always use safety goggles when using dry compressed air.  Do not use pressures greater than 30 psi.  High air pressure can cause injury and cut the skin. b. Remove all Use low pressure traces of compressed air. carbon dust. DO NOT spin bearings with compressed air. c. Inspect visually for Cracks, Corrosion, Local discolo- ration, and Wear. 2-65







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.