GENERAL INFORMATION (Contd)
The Bridge Erection Boat (BEB) is covered by a warranty. All U.S. Army customers requiring warranty
assistance will initiate direct contact through respective unit Warranty Coordinators (WARCOs). WARCOs
will submit all warranty claims for non-consumable items, greater than one-hundred dollars, to the FBM
Babcock Marine Ltd. Point of Contact (POC) identified below. Request all claims be submitted both
electronically and telephonically.
BEB warranty coverage applies to the following end item:
BRIDGE ERECTION BOAT
The BEB MK II-S warranty period provides coverage on the boat and its components for 12 months starting
on the date of customer handoff, if entering service, or 15 months from the date of customer handoff, if
placed in storage. All warranty claims must be filled out on a warranty form, available on FBM's website,
and then e-mailed to FBM for evaluation and action.
Minor defects in manufacturing and/or assembly will be corrected by MRBC personnel and a record of each
incident must be provided to FBM.
Replacement parts will be provided by FBM and installed by MRBC personnel or a designated FBM
representative. If the MRBC carries the required replacement part and is able to install it without delay,
FBM will provide a replacement.
Engine related claims will be processed by FBM and resolved by a local Cummins dealership representative
in the area. Hydrojet related claims will also be arranged by FBM and evaluated and resolved by an Ultra
The POC for all warranty claims is:
FBM Babcock Marine Ltd
BEB Service Department
St. Cross Business Park
Monks Brook, Newport
Isle of Wight, P030 5BF
Phone: +44(0) 1983 825700
Fax: +44(0) 1983 824180
NOMENCLATURE CROSS-REFERENCE LIST
Refer to the glossary in the back of this manual for a list of the approved nomenclature appearing in this
TM and common unofficial nomenclature. A list of nautical terminology is also provided.
LIST OF ABBREVIATIONS/ACRONYMS
For a list of standard abbreviations, refer to ASME Y14.38.
QUALITY OF MATERIAL
Material used for replacement, repair, or modification must meet the requirements of this manual. If
quality of material requirements are not stated in this manual, the material must meet the requirements of
the drawings, standards, specifications, or approved Engineering Change Proposals (ECP) applicable to the
SAFETY, CARE, AND HANDLING
Observe all warnings, cautions, and notes prior to operating and servicing equipment. If uncertain how to
perform any operator's procedure, ask your supervisor for assistance.
Equipment data is presented in U.S. standard measurements followed by metric equivalents. The BEB
requires the use of both U.S. standard and metric tools.
END OF WORK PACKAGE