TM 5-1940-322-24
0032 00
ENGINE STOP CONTROL CABLE AND HANDLE REPLACEMENT (Contd)
NOTE
Both engine stop control cables and handles are replaced the same
way. This procedure covers replacement of one engine stop control
cable and one handle.
REMOVAL
1.
Remove two locknuts (8), washers (9), cable clamps (10), screws (12) and cable (13) from bracket (11).
Discard locknuts (8).
2.
Remove screw (18), cotter pin (14), and washer (15) from trunnion (17). Discard cotter pin (14).
3.
Remove trunnion (17) from injection pump stop lever (16).
4.
Hold nut (2) and remove handle (1) from cable (7).
5.
Remove nuts (2) and (3) from cable (7).
6.
Remove cable (7) from console panel (4).
7.
Remove washer (5) and nut (6) from cable (7).
INSTALLATION
1.
Install nut (6) and washer (5) on cable (7).
2.
Position cable (7) through existing hole in console panel (4).
3.
Secure cable (7) on console panel (4) with nuts (3) and (2).
4.
Hold nut (2) and screw on handle (1).
5.
Position handle (1) against console panel (4).
6.
Install trunnion (17) on injection pump stop lever (16) with washer (15) and new cotter pin (14).
7.
Install cable (13) through trunnion (17).
8.
Secure cable (13) on bracket (11) with two screws (12), cable clamps (10), washers (9), and new
locknuts (8).
9.
Adjust cable (13) and install screw (18) on trunnion (17).
10.
Close and secure control panel access panel (TM 5-1940-322-10).
11.
Start engine and shut down using engine stop handle (1). If necessary, readjust cable.
12.
Close engine hatches (TM 5-1940-322-10).
0032 00-2