TRANSMISSION INSPECTION (Contd)
Inspect bearings for damage or roughness of rotation. Replace if damage or roughness of rotation is
Inspect bearings for corrosion; scored, scratched, cracked, pitted, or chipped races; and for indication of
excessive wear of balls or rollers. If defect or damage is present, replace part.
Inspect bearing bores and shafts for grooved, burred, or galled conditions that indicate bearing has
been turning in its housing or on its shaft. If damage cannot be repaired with crocus cloth, replace
BUSHINGS AND SLEEVES
Inspect bushings for out-of-roundness, scores, burrs, sharp edges, and evidence of overheating.
Remove scores with crocus cloth.
If bushing is out-of-round, deeply scored, or excessively worn, replace bushing.
THRUST WASHERS AND SPACERS
Inspect thrust washers for distortion, scores, burrs, or wear. Rework or replace if defect is present.
Inspect gears for scuffed, nicked, burred, or broken teeth. If defect cannot be removed with soft stone,
Inspect gear teeth for wear that may have destroyed original tooth shape. If defect is found, replace
Inspect thrust faces of gears for scores, scratches, and burrs. If defects cannot be removed with soft
stone, replace gear.
Inspect splined parts for stripped, twisted, chipped, or burred splines. Remove burrs with soft stone. If
other damage is present, replace part.
Replace damaged or distorted snaprings.
Inspect springs for broken or distorted coils. If damage is present, replace springs.
Inspect flexible hoses for cracks and sponginess. If damage is present, replace hose.
END OF WORK PACKAGE