TM 5-1940-322-24
0166 00
TRANSMISSION REPAIR (Contd)
CLUTCH PACK DISASSEMBLY (Contd)
CAUTION
Do not remove front-tapered roller bearings from forward or
reverse clutch pack shafts unless bearing replacement is necessary.
Close tolerance between inner bearing cone and transfer gear face
prohibits installation of bearing puller behind inner cone.
10.
If front-tapered roller bearing must be removed, perform the following steps.
a. Split bearing cage (2) and remove roller bearings (3) and cage (2) from bearing cone (4).
b. Install bearing puller over edge (5) of bearing cone (4), gripping against shoulder on bearing cone (4).
CAUTION
Prolonged or excessive heating must be avoided so shaft will not be
annealed.
c. Apply pulling force to puller, flash-heat bearing cone (4), and remove bearing cone (4) from clutch
pack shaft (1).
CAUTION
Do not remove driving transfer gears from shafts. Shaft and gear
are supplied as an assembly only.
11.
Repeat steps 1 thought 10 to disassemble reverse clutch pack.
1
5
4
1
2
4
3
BEARING PULLER
0166 00-6