• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Roller Assembly
Figure  4-3.  Push-pull release cable.

TM-5-2090-200-12P Cradle Boat 27 FT: Bridge Erection Boat NSN 2090-00-348-8138 Manual
Page Navigation
  30    31    32    33    34  35  36    37    38    39    40  
TM 5-2090-200-12&P wheels are listed through the access cutouts and clear of the side beams. b. Disassembly. (1)   Set the dolly on blocks or dunnage. (2)   Slide the wheels off of the axles. (3)   Remove   the   capscrews,   lockwashers   and   flat   washers   and   slide   the   axles   from   their housings. c. Cleaning and Inspection. (1)   Inspect the dolly for cracks, dents, or other damage and for missing or damaged parts. (2)   Remove dirt, grease or oil from the dolly. (3)   Replace any missing or damaged parts. d. Reassembly. (1)   Install  the  axle  in  the  dolly  housing  and  secure  with  the  capscrew,  lockwasher  and  flat washer. (2) Slide the wheels on the axle until secure. e. Installation. (1)   Remove the access covers and lower the two front dolly wheels through the access cutouts. (2)   Move the dolly so that the remaining two wheels line up with the access cutouts and lower the wheels through the cutouts. (3)   Install the access cover and secure with capscrew, lockwasher and flat washer. 4-19. Push-Pull Release Cable a. Removal. (1)   Remove cotter pin (12, fig.  2-5) and cable stop (13). (2) Remove four nuts (1, fig.  4-3), lockwasher (2)   and screws (3) from clamp (4).  Remove two nuts (5), washer (6), and screws (7) and remove the cable clamps (4 and 8). (3)   Remove screws (10), nuts (14), washers (15), and clamps (11). (4)   Remove screw (9) and clamp (11) and remove the push-pull release cable (12). b. Cleaning and Inspection. (1) Inspect the push-pull release cable for damage, wear, and missing parts. WARNING Dry  cleaning  solvent,  P-D-680  or  P-S-661.,  used  to  cleaner  parts  is  potentially  dangerous  to personnel  and  property.    Avoid  repeated  and  prolonged  skin  contact.    Do  not  use  near  open flame or excessive heat.  Flash point of solvent is 100 F.  138 F.  (38 C.  59 C.). (2) Clean the push-pull release cable with cleaning solvent (Fed.  Spec.  P-D-680) and dry thoroughly. c. Installation. (1)   Place the push-pull release cable (12) in position and secure it at the top with clamp (11) and screw (9). (2)   Secure the center of the cable with clamps (11), nuts (14), and washers (15). (3)   Secure the cable at the bottom by installing clamps (4 and 8).  Install clamp (8) with Nuts (5), washers (6), and screws (7).  Install clamp {4,with nuts (1), lockwasher (2) and screws (3). (4)  Attach the cable at the bottom to the latch assembly (fig.  2-5) with the cable stop (13, fig.  2- 5) and cotter pin (12). 4-7







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.