P r e v e n t i v e M a i n t e n a n c e C h e c k s and Services for M60A1 AVLB Hull-
Not Fully Mission
Service dust detector filter strip.
Filter Strip (Left
and Right Sides)
Cut off approximately 2-inches from
end of filter strip.
Pull filter strip so that approximate
ly 1/2-inch will extend past edge of
cover when falter strip is installed.
Install filter strip and retainer in
cover. Filter strip must be approxi-
mately 1/2-inch past edge of cover.
Ensure all orifices are clean.
Install cover. Tighten three screws.
Perform dust detector operational
test (page 10-298.17).