TM 5-5420-202 -20-2
TRANSMISSION SHROUD REPAIR (Sheet 5 of 6)
Position insulation (A) on shroud (B).
Using 7/16 inch socket, install retainer (C) to shroud with 25 screws (D), 21 washers (E),
and four new key washers (F). Be sure to position four key washers (F) properly and bend
tabs with chisel and hammer.
Both parts of turn lock fasteners must be pointing
in the same direction.
Using 3/4 inch socket and 3/4 inch wrench, install three turnlock fasteners (G) to both
sides of shroud (B). Use new self-locking nuts.
Using slip joint pliers, install new lockwire in 21 screws (D) (page C-34).
Go on to Sheet 6