ENGINE WIRING HARNESS REPLACEMENT (Sheet 9 of 12)
Place wiring harness (A) in position.
Place two clamps (T) in position
around wiring harness (A).
Using 1/2 inch socket with extension,
securing two clamps (T) to engine.
Using slip joint pliers, install
connector (V) to fuel-water
separator control (W).
Place two clamps (X)
in position around wiri
Using 1/2 inch socket with extension
securing clamps (X) to engine.
20. Using slip joint pliers, install
Using 7/8 inch wrench install
fuel shutoff lead (AB) to front
22. Place clamp (AC) (hidden) in position
Using 9/16 inch wrench, install nut
securing cable and clamp (AC).
Go on to Sheet 10