SHIFTING CONTROL AND RELATED PARTS REPAIR AND REPLACEMENT (Sheet 3 of 14)
Using 9/16 inch wrench, remove bolt
(F) securing link (G) to rod (H). Let
rod (H) drop below floor.
Using socket and extension, remove four
washers (L) from bracket assembly (M).
Using socket and extension, tighten screws
installed in steps 3, 4, and 5, alternately.
Using socket and extension, remove three
washers (R) from base assembly (S).
Remove base assembly (S) and bracket
assembly (M) as a single unit from vehicle.
Using pencil and masking tape, tag all
shims (T) found under bases (S) and (M).
Go on to Sheet 4