MASTER BRAKE CYLINDER-TO-BULKHEAD TUBE ASSEMBLY REPLACEMENT (Sheet 2 of 5)
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away from flames,
sparks, or heat. Do not smoke while using. Prevent contact with eyes, mouth, and/or skin. Wear
rubber gloves when performing cleaning procedures.
Using dry cleaning solvent and rags,
clean entire tube assembly and connec-
tions at bulkhead and master cylinder.
Using hands, place funnel and container
under reducer (A) to catch draining
Using 13/16 inch wrench to hold reducer
(A), use 11/16 inch wrench to remove tube
connecting nut (B). Cap reducer (A).
Place rags under union (C) at bulkhead to catch dripping brake fluid. Have
cap ready to place on nipple (D).
Using 7/8 inch wrench to hold nut (F), use 11/16 inch wrench to remove tube
nut (E). Install cap on nipple (D).
G O on to Sheet 3
T A2 4 9 4 3 0