BRAKE QUICK-DISCONNECT AND HOSE ASSEMBLY REPLACEMENT (Sheet 5 of 7)
Remove plastic plugs from tube assemblies (E and F) and position assembled parts (A
thru D) with tee (D) between tube assemblies (E and F).
Tighten nuts of tube assemblies (E and F) to tee (D) finger tight.
Remove screw (G) and lockwasher (H)
holding adjusting screw lock plate.
Position bracket (B) over adjusting screw
lock plate. Insert screw (G) and lock-
washer (H). Tighten finger tight.
Using 9/16 inch socket, tighten screw
Using adjustable wrench to hold tee (D)
and 11/16 inch wrench, tighten nuts of
tube assemblies (E and F).
Using 11/16 inch wrench, tighten nut
of tee (D).
Thread nut of tee (J) on coupling half
(K) finger tight.
Using 13/16 inch wrench to hold coupling
half (K) and 11/16 inch wrench on nut
of tee (J), tighten nut.
Go on to Sheet 6
Change 6 13-51