TM 5-5420-202-20-3
BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 6)
Using 9/16 inch socket, disconnect mounting
nut from stud.
Remove slave cylinder (H).
Using putty knife, remove packing (M)
from groove of slave cylinder (H) and
throw away packing.
CLEANING AND INSPECTION:
Dry cleaning solvent P-D-680 is toxic and flammable. To prevent personal injury, wear
protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaing Solvent is 100F (38C) and for Type #2 is 138F (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
1.
Clean all metallic parts in dry cleaning solvent.
2.
Inspect all parts for damage or wear. Replace all unserviceable parts.
3.
Inspect tube assembly nut for cracks. Replace tube assembly if any cracks are found.
4.
Check bolt (F) for open and clean internal passages.
Go on to Sheet 4