PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 7 of 15)
Using grease pencil, mark the distance
that both clevises (BB) are threaded
onto control assembly inner rods (BC).
Remove both clevises (BB).
Using 15/16 inch wrench, remove both nuts (BD).
Using 9/16 inch wrench to hold flats (AT and BE) of control assemblies (F and S) and using
15/16 inch wrench, remove nuts (BF) and washers (BG).
Pull control assemblies (F and S) out of brackets (BH).
Using 15/16 inch wrench, remove washers (BJ) and nuts (BK).
Go on to Sheet 8