PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT (Sheet 7 of 9)
Using two 9/16 in. wrenches, loosen two nuts (R) and (S) on end of shaft (K). Do not allow
shaft to turn or damae to control will result.
Push or pull shaft (K) until 1-1/8 in. gage block just fits between cotter pin (M) and sleeve
With gage block in place, rotate upper nut (R) until metal to metal contact exists between
upper nut (R) and lever assembly (T).
Using 9/16 in. wrench back off upper nut (R) 1-1/2 turns.
Using two 9/16 in. wrenches, hold nut (R) and lock lower nut (S) securely against upper
G O on to Sheet 8