TRACK SUPPORT ROLLER REPLACEMENT (Sheet 3 of 11)
If plank or base plate is not available, position jack on
roadwheel near roller and raise track.
If hydraulic jack is not available, disconnect track (TM 5-5420-
202-10). Then move vehicle in reverse until track is off roller.
Using wooden plank or metal plate as base on
roadwheel, position hydraulic jack.
Using jack, raise track so it clears roller.
Safety block must be installed as
Using 9/16 inch socket, remove six screws (A),
access cover plate (D) and gasket (E). Throw
gasket (E) away.
GO on to Sheet 4