T142 TRACK LINK REPLACEMENT (Sheet 2 of 3)
Position link to be replaced between
compensating idler wheel and road-
wheel No. 1. Disconnect track at
link to be replaced.
It will be
necessary to remove end connectors
and centerguide on both sides of
Using 15/16 inch socket with ratchet,
loosen bolt (A) securing wedge (B) to end
Using hammer, tap wedge (B) to loosen
Remove bolt and wedge. Throw both
Repeat steps 1 thru 3 to remove bolt and
wedge at opposite side of track.
Put hook (D) of track end connector puller and
pump behind end connector (C).
Aline studs (E) of track end connector puller
and pump with shoe pins (F).
Pump handle (G) until end connector (C)
Repeat steps 5, 6, and 7 to remove
opposite end connector.
Go on to Sheet 3