SHOCK ABSORBER BEARING REPAIR (Sheet 1 of 2)
1-1/2 in. socket with 3/4 in. drive
SPECIAL TOOLS: Shock absorber bearing replacer (Item 26, Chapter 3, Section I)
PRELIMINARY PROCEDURE: Remove shock absorber from vehicle (page 14-93)
Using hammer and chisel, cut off stakes (A)
(three places, each side).
Using bearing replacer, remove bearing (B).
Put shorter threaded end of screw (C) through
bore of bearing (B).
Screw base (D) of special tool onto shorter end.
Base should mate to one side of bearing bore.
Go on to Sheet 2