FRONT STEERING CONTROL TUBE REPLACEMENT (Sheet 3 of 3)
Using 9/16 inch wrench, install jamnuts (A) and rod ends (B) on rod.
Using steel tape, measure between centers of holes in rod ends (B).
Using 9/16 inch wench, turn rod ends (B) until recorded measurement is obtained.
Using torque wrench and crowfoot adapter, tighten jamnut (A) against rod ends (B) to a
minimum torque of 192 lb-in. (22 N.m).
Aline rod end (B) in link (C).
Using 9/16 inch wrench, install bolt (D) in link (C).
Aline other rod end (B) in lever (E).
Using 9/16 inch wrench, install bolt
(F) in lever (E).
Test operation of front steering control
End of Task