FENDER AND SHIELD (REAR) REPLACEMENT (Sheet 2 of 7)
Using 9/16 inch socket, remove three locknuts and washers (G) holding fender (E) to
support No. 5 (H).
Using 9/16 inch socket, remove remaining three nuts and washers (J) holding support No. 5
(H) to stowage box apron (K).
Using 9/16 inch socket on two screws (L) and 9/16 inch open end wrench on two locknuts
(M), remove two screws (L), washers (N), and nuts (M) holding shield (P) to taillight bracket
Remove fender (E) and shield (Q) from vehicle.
Go on to Sheet 3