Using 1/4 inch flat-tip screwdriver,
install screw (N) and lockwasher (P),
to secure capacitor ground strap (Q)
to armature end of motor (C).
Slide insulator (R) over end of capacitor
lead (S) and connect lead (S) to lead (T)
at end of motor as shown, then slide
insulator (R) over connectors.
Install new packing (U) in groove in housing
Position cover (V) to housing (H).
(X) to secure cover (V) to housing (H).
Using 1/4 inch screwdriver, tighten
10 screws (W).
Place retaining clamp (Y) in position
over both electrical leads (Z). Using
3/8 inch flat-tip screwdriver, install
clamp (Y) to housing (K) with lockwasher
(AA) and screw (AB).
Using 3/8 inch flat-tip screwdriver,
tighten screw (AB).
Install air cleaner blower fan (TM 5-5420-
End of Task