TM 5-5420-202-34
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPLACEMENT (Sheet 4 of 6)
INSTALLATION:
1.
Using 9/16 inch socket and 9/16 inch wrench, install two screws (A), four flat washers
(B), two lockwashers (C), and two nuts (D) to secure bracket (E) to accelerator control
linkage assembly (F).
Using both hands, lift accelerator control linkage assembly (F) into engine compartment.
2.
3.
Using both hands, position accelerator control linkage assembly (F) to rear wall of bulkhead.
4.
Aline tube assembly of accelerator control linkage assembly (F) with access hole in bulkhead.
Push accelerator control linkage assembly (F) forward until tube assembly studs pass
5.
through access hole in bulkhead.
Go on to Sheet 5