TM 5-5420-202-34
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPAIR (Sheet 5 of 13)
22.
Using 1/2 inch socket, remove two screws
and two lockwashers (AC) holding clevis
with shaft (W) to control housing (J).
23.
Pull clevis with shaft (W), two bearings
(AD), housing (V), and clevis rod end
(U) from control housing (J) as an assembly.
24.
Using 7/16 inch wrench, remove screw
and lockwasher (AE) from clevis (U).
25.
Using pry bar, pry clevis (U) from clevis
with shaft (W).
26.
Using screwdriver, remove woodruff
key (AF) from clevis with shaft (W).
Throw key away.
27.
Pull housing (V) from clevis with shaft
(W). Do not try to remove two bearings
(AD) from housing (V) unless beyond
wear limits (page 4-106).
28.
Using socket head screw key, remove
drain plug (AG) from control housing
(J).
Go on to Sheet 6
4-103