ACCELERATOR CONTROL LINK A G E ASSEMBLY REPAIR (Sheet 12 of 13)
Install new gasket (AB) into groove on
bottom of riser housing (U).
Slide tube assembly (P) through shaft
(AC) and onto control housing (B).
Place riser housing (U) with gasket
(AB) on control housing assembly (B).
Using 1/2 inch wrench, install seven screws
(U) to control housing assembly (B).
Aline tube assembly bearing (AE) within
Using 7/16 inch wrench, install screw
(AG) to hold tube assembly (P) to lever
Go on to Sheet 13