FRONT ACCESSORY HARNESS REPLACEMENT (Sheet 11 of 14)
Route wiring harness assembly (A) along right side of hull to clip bracket assembly (AH)
below right headlight.
W h e n installing harness,
make sure circuit numbers
of all electrical leads match
with mating leads.
Connect five connectors (AJ), CKT
17, 18, 20, 514, and 515 to connectors
(AK). Press connectors into clips of
Connect connector (AJ) CKT 19 to dummy load in bracket (AH).
Using 7/16 inch socket, install three straps (AL), flat washers (AM), lockwashers
(AN), and screws (AP) securing wiring harness assembly (A).
Using 5/8 inch wrench, install electrical lead (AQ) and nut (AR) to terminal of center
Go on to Sheet 12