TRANSMISSION REPLACEMENT (Sheet 4 of 23)
Using 3/4 inch socket, remove two nuts
and washers (W).
Using 3/4 inch wrench, remove screw
and washer (X).
Remove bracket (Y) and rod (Z) from trans-
mission as a unit.
Using 3/4 inch wrench, remove nut (AA).
18.1. Using 7/8 inch wrench, disconnect nut (AB)
from elbow (AC).
18.2. Using adjustable wrench, remove elbow (AC).
If transmission is mated to a 2D engine,
use a 7/8 inch wrench and disconnect nut
(AD) from elbow (AE). Remove transmission
vent line (AE.1) from transmission.
If transmission is mated to a 2DA engine,
use a 3/4 inch wrench and disconnect nut
(AE.2) from elbow (AE.3). Remove trans-
mission vent line (AE.4) from transmission.
Go on to Sheet 5