TM 5-5420-202-34
TRANSMISSION REPLACEMENT (Sheet 21 of 23)
54.
Install nut (BN) on stud.
Position bracket (BP) and rod (BQ) onto
transmission. Using 3/4 inch wrench
install screw (BR) through washer (BS),
bracket (BP) and into nut (BN).
55.
Using 3/4 inch socket, install two nuts (BT)
and washers (BU) onto studs.
NOTE
Make sure to aline lever (BV) with
slot on shaft
56.
Position lever (BV) onto shaft. Using
9/16 inch socket, install nut and
washer (BW) onto stud.
57.
Using pliers, install new cotter pin (BX)
through shaft.
58.
Using two 9/16 inch wrenches, tighten
nut (BY) and screw (BZ).
59.
Position rod (BQ) into lever (BV) and,
using 9/16 inch socket, install screw
(CA) through lever (BV) and rod end
(CB).
Go on to Sheet 22
6-39