TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 3 of 30)
NOTE
There are two different types of final
drives. Early model has three holes in
end of shaft and late model shaft has
five holes. Before performing this proce-
dure, identify which final drive you have
(early or late). Where the final drive re-
pair differs, it will be noted.
DISASSEMBLY:
Using lifting device, position final drive over
1.
drain pan.
2.
Using hinged bar with 1/2 inch drive or 5/8
inch socket head screw key (allen wrench),
remove four pipe plugs (A).
3.
Allow oil to drain completely. When drained,
place final drive assembly on working area.
4.
Using 7/16 inch wrench, remove pressure
relief valve (B) or vent elbow (B).
5.
Using 3/16 inch allen wrench, remove plug
(C).
Inspect 17 studs (D) for wear or damage.
6.
Replace as necessary.
Go on to Sheet 4
Change 2 7 - 3