Using 1-1/8 inch wrench, remove filler cap (C) and gasket (D) from cylinder (A).
Using 3/8 inch wrench, remove bleeder
Using 3/4 inch wrench, remove plug (F)
and gasket (G).
Insert cross-tip screwdriver in cylinder (A) and press in piston (H) while removing retaining
ring (J) with flat-tip screwdriver.
Insert flat-tip screwdriver through hole (K), push out washer (L), piston (H), cup (M), spring
(N), and retainer (P).
Remove retainer (P) from spring (N).
Separate spring (Q) from retainer (P) by pressing on valve (R) and turning.
Insert screwdriver through hole (K) and remove seat (S) from cylinder (A).
Go on to Sheet 3