ROADWHEEL ARM REPAIR (NUMBER 1 LEFT AND RIGHT) (Sheet 4 of 7)
Using hammer and chisel, cut off stakes
on three places each side of shock
absorber bearing (G) and track adjusting
link bearing (H).
If your vehicle is equipped with mechanical track adjusting
link, perform steps 9 and 10; if equipped with grease actuated
track adjusting link, perform steps 9 and 11.
Install replacer on bearing (G). Turn replacer
nut until bearing (G) is removed. Throw
bearing (G) away.
Install bearing driver on bearing (H).
Turn nut of bearing driver until bearing
(H) is removed. Throw bearing (H) away.
Secure bearing tool assembly to bearing (H)
with screw and nut. Install puller to bearing
tool assembly and remove bearing (H). Throw
bearing (H) away.
Go to Sheet 4.1
Change 2 9-4.1/(9-4.2