TRACK SUPPORT AXLE ASSEMBLY REPAIR (NUMBER 1 THROUGH 3 LEFT AND RIGHT)
(Sheet 1 of 2)
Drive collar bushing 2-9/16 in. inside dia. 8 in. lg.
PRELIMINARY PROCEDURES: Remove hub and bearings (TM 5-5420-202-20)
Remove axle assembly (TM 5-5420-202-20)
Secure axle assembly (A) in vise.
Using hammer and chisel, remove spacer (B). Throw spacer (B) away.
Ensure area is clear of combustible materials to prevent fire.
Wear goggles and gloves to prevent injury.
If spacer (B) will not come off, use oxygen-acetylene torch as a heat source and apply
heat to spacer (B) and repeat step 2.
Go on to Sheet 2