TM 5-5420-202-34
STEERING CONTROL SLEEVE ASSEMBLY REPLACEMENT AND REPAIR (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
10-3
Disassembly
10-4
Assembly
10-5
Installation
10-6
TOOLS:
6 in. rule
Torque wrench with 3/8 in. drive
5/16 in. combination box and
(0-200 lb-in) (0-23 Nm)
open end wrench
7/16 in. crowfoot wrench with
7/16 in. combination box and
3/8 in, drive
open end wrench
9/16 in. crowfoot wrench with
9/16 in. combination box and
3/8 in, drive
open end wrench (2 required)
9/16 in. socket with 3/8 in. drive
Hammer
1/8 in. hex wrench, six point (allen)
Vise
Ratchet with 3/8 in. drive
FABRICATED TOOL: Bearing installation and
removal tool (Figure D-2,
Seal (2 required)
SUPPLIES:
Bearing
REMOVAL:
1.
Using 9/16 inch wrench, remove screw (A) securing front intermediate rod (B) to bulkhead
shaft rod end (C).
2.
Using 9/16 inch wrench to hold nut (D), use 9/16 inch wrench to remove rod end (C).
Go on to Sheet 2
