TM 5-5420-202-34
DISASSEMBLY:
1.
Using screwdriver, remove four
(B) that hold cover (C) to case
(D).
Lift cover (C) with wires (E)
2.
attached, so you can get to parts
inside case (D).
3.
Remove gasket (F) by sliding
over cover (C). Discard gasket.
4.
Using knife, remove insulation sleeving from four terminals of switch
(G).
Using masking tape, tag and mark each wire (H) connected to terminals
5.
of switch (G).
6.
Using soldering iron, unsolder electrical wires (H) from terminals of switch
(G).
7.
Using wrench, remove nut (J), lockwasher (K), and switch guard (L) from
switch (G).
Remove switch (G) from cover (C).
8.
9.
Remove packing (M), key washer (N),
and flat washer (P) from switch (G).
Discard packing.
Go on to Sheet 5
12-4