TM 5-5420-209-12
3-21. Hydraulic Filter Assembly.
This task covers: Service
INITIAL SETUP
Tool
Materials/Parts
General Mechanics Automotive Tool Kit
Packing, Preformed (P/N 576366-7)
(Item 1, Appendix B)
Hydraulic Filter Element (P/N 576366-5110)
Solvent, Dry Cleaning (Item 18, Appendix E)
Rags, Wiping (Item 12, Appendix E)
a. Service. (figure 3-18)
(1)
Remove plug (1) and drain hydraulic fluid into suitable container.
(2) Remove four screws (2), washers (3), and remove lower housing (4), element (5), seal (6), and packing (7).
(3) Remove element (5) from lower housing (4).
WARNING
Dry cleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and property.
Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. Flash point
of solvent is 100-138°F (38-60 °C).
(4) Discard seal (6) and packing (7).
(5) Clean lower housing (4) with dry cleaning solvent and air dry thoroughly.
(6) Install packing (7), seal (6), and element (5) in lower housing (4).
(7) Install lower housing (4) and secure with four washers (3) and screws (2).
(8) Install plug (1) and tighten to snug plus one quarter turn.
3-38