ENGINE MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 2 of 3)
Using 1-1/8 inch open end wrench to hold nut
(D) and 1-1/8 inch socket on bolt (E), remove
nut (D) and bolt (E) from, bracket (F).
Using 1-1/8 inch socket, remove bolt (G) and
washer (H) from bracket (F) while holding
bushing (J) with 3/4 inch drive T-slide and
36 inch extension bar.
Remove bushing (J), mount (K), mounting (L),
and mount (M) from engine assembly.
CLEANING AND INSPECTION:
Clean all parts with drycleaning solvent and
wipe dry with clean rag.
Inspect bushing, mounts, and mountings for
nicks and burrs. Replace damaged parts.
Go on to Sheet 3