TM 5-5420-226 -20-2
MULTIPLE FLUID PRESSURE LINE CONNECTOR REPLACEMENT (Sheet 4 of 6)
Connect hose (D) to connector (A).
Using 1 inch wrench, tighten hose connector
(D). Make sure connector (A) is installed
with hose fittings pointed down.
Connect hoses (E) and (F) t o c o n n e c t o r ( A ) .
Using 11/16 inch wrench, tighten connectors
(E) and (F).
RIGHT ENGINE SHROUD
P o s i t i o n hose (F) so that free end passes
t h r o u g h right engine shroud. Using fingers
a n d flat-tip screwdriver position grommet (G)
o v e r hose and into shroud.
Go on to Sheet 5