ACCELERATOR CONTROL ROD REPLACEMENT (Sheet 2 of 5)
Using retaining ring pliers, remove two
retaining rings (B) from grooves (C)
in control rod (D).
Remove housing (E) from control
Using 7/16 inch socket and ratchet,
remove three screws (F) and lock-
Using 9/16 inch socket and ratcher
flat washers (K), and shim (L) (if so
Remove housing (M) from control rod (D).
Using hammer and drive punch, remove
bushings (N) from housings (E) and (M).
Using hammer and drive punch, tap
control rod (D) out of link (P) and
Go on to Sheet 3