FUEL TANK (LEFT) REPLACEMENT (Sheet 11 of 16)
Using 15/16 inch wrench, install washer
(D) and nut (E) to front mount (F). Thighten
three nuts (G).
Using 15/16 inch wrench, adjust front
mount (F) until 1/2 inch clearance is
obtained between fuel tank (C) and bulkhead
Position mount (J) in fuel tank bracket
and rotate 180 degrees. Using 1/2 inch
wrench, install lower front mount (J) to
hull floor using two screws and washers (K).
Using two 15/16 inch wrenches, tighten
screw (L) and nut (M).
Go on to Sheet 12